Send us the bent shaft of your TT and we will straighten it - no charge.  Please follow the instructions on the Return Form (http://www.biospec.com/NonContamination%20Notice.pdf).

 

Or - you can do it yourself:  Take the rotor out of the motor.  Lay it on a flat, hard surface (table, lab bench, etc) and roll it slowly.  View the space or gap between the rotor shaft and the table.  Note as you roll it, it shows where the rotor is bent.  Using a small hammer, gently hit the high spot on the rotor.  Roll and repeat at least a dozen times until you are convinced that you are unable to make any further improvement.  That is probably enough.  You can reassemble and use the now straightened TT.